fosroc construction chemicals

Approx. Rs 540 / KgGet Latest Price

• Conbextra GP2 (N) is a blend of Portland cement, gradedfillers and chemical additives which impart controlled expansion in the plastic state whilst minimising water demand. The low water demand ensures high early strength. The graded fi llers are designed to assist uniform mixing and produce a consistent grout.

Approx. Rs 100 / KgGet Latest Price

Approx. Rs 100 / KgGet Latest Price

Lokfix is a two-component polyester resin anchoring grout, meeting the requirements of BS EN 1504-6: Anchoring of reinforced steel bars.

Supplied in pre-measured quantities, the material cures quickly to give consistent, high performance anchorages.

Lokfix P : Thixotropic grade, 25 minute gel at 20°C for use in overhead or horizontal holes where the hole is up to 25 mm greater in diameter than the bar. The thixotropic nature of Lokfix P reduces flow of grout out of the hole.

• Rapid strength gain.
• Vibration resistant.
• Corrosion resistant.
• Non-expansive.
• Can be placed underwater

• Rapid strength gain
• Vibration resistant
• Corrosion resistant
• Non expansive
• Can be placed under water

Hole preparation and formation

• Optimum performance of Lokfix requires rough sided, dust free holes. Uses of rotary percussive drills with air or water fl ushing is recommended.
• Diamond drilled holes should be under-reamed unless necessary safety factors are incorporated.
• Cast holes should preferably be inverse dovetail configuration.
• If parallel sides holes are cast they should be rough to provide adequate keying.

Bar preparation

• All bars should preferably be degreased and all flaky rust removed.

Mixing

• A complete pack of resin and catalysed filler should be mixed in one operation. Mixing may be carried out mechanically. When a smooth, even consistency is achieved the grout is ready for use and should be placed well within the gel time of the grout (See datasheet).
• Packs have been designed to produce practical and economic volumes of grout.
• Do not attempt to mix partial pack components.

Installation

• The grout should be injected to the rear of the hole to avoid air entrapment. The thixotropic nature of Lokfix P will prevent significant flow of resin out of the hole.
• The anchor bar is then pressed into the hole to the required depth.
• Slight agitation of the bar will assist in achieving a complete bond. The bar should then be left undisturbed in the required position until the resin is set.

Additional Information:

• Production Capacity: AS PER REQUIREMENT
• Delivery Time: 2DAYS

Approx. Rs 100 / KgGet Latest Price

Approx. Rs 9,000 / 20 LitreGet Latest Price

Approx. Rs 5,000 / BagGet Latest Price